Breaking Mk1b T bar in white with 3S-GE

[Lee Haslam]

Due to no interest in the car I have taken some parts off to fit on my other white mk1 and the rest is for breaking unfortunately.

Rev 4 3S-GE engine with rev 3 loom. Loom is uncut and engine comes with all ancilleries to make it run £200

Rev 2 NA gearbox £50

Magnex backbox in perfect condition £100

Mk3 staggered wheels in good condition, fronts with 185/55 Bridgestone Potenzas and rears with 195/50 Eagle F1's on £175

40mm lowering springs, almost new £45

Front bumper bar, no holes, couple of tiny patches welded on £45

Passenger side front wing, good condition £50

T Bar seals £35

Brand new radiator (cost me £120), £80

Front bumper £25

Lots of blue interior parts £offers

Anything else you could possibly want please ask.

http://www.mr2mk1club.com/images/imported/2010/07/0037-1.jpg

http://www.mr2mk1club.com/images/imported/2010/07/0058-1.jpg

http://www.mr2mk1club.com/images/imported/2010/07/0046-1.jpg

http://www.mr2mk1club.com/images/imported/2010/07/0112-1.jpg

http://www.mr2mk1club.com/images/imported/2010/07/035-1.jpg

[corkcorolla]

Dibs on the 2 front doors please,can you get some pics up of them,especially the bottoms of both doors.

What does the ST185 brake setup come with?

I'll have an exact list of other parts i'm interested in by tomorrow anyway.

[Lee Haslam]

Won't be able to get pics of the doors before weekend as car is in a garage a few miles from my house with no electric. Its dark when I go to work and when I get home now with the clocks going back so impossible to get decent pictures. I can assure you the doors are really good as I was going to swap them onto my new car if they don't sell.

The brakes will come with disks, calipers and pads. It uses the standard mk1 brake lines.

[corkcorolla]

Ok,i'll take your word on it.

I'll have that list tomorrow anyway,put me down provisionally to take the brake setup aswell,i'm sure you'll do me some deal if I buy a few bits ;)

What time do you finish work Friday,I should hopefully be in Manchester around 2:30-3pm. :+:

[Lee Haslam]

Ok,i'll take your word on it.

I'll have that list tomorrow anyway,put me down provisionally to take the brake setup aswell,i'm sure you'll do me some deal if I buy a few bits ;)

What time do you finish work Friday,I should hopefully be in Manchester around 2:30-3pm. :+:

finish at 4 so usually home about 5ish depending on traffic. Only issue is going to be stripping parts off the car in the dark if doing it Friday night.

[corkcorolla]

quote]

finish at 4 so usually home about 5ish depending on traffic. Only issue is going to be stripping parts off the car in the dark if doing it Friday night.[/quote]

I'll be around for a few hours Saturday morning,we could do it then,maybe you could take off a few of the smaller bits during the week?

I'll pm you there with the full list of stuff i'm interested in. :+:

[88mister2]

Hi Lee,
I am interested in the front passenger wing if it is available. Could you pm me when it would be convenient to have a look at it. I am in the M24 area.
Cheers Denis

[No3157]

Erm...did you gey my pm?? :wave:

[Lee Haslam]

Doors, brakes and rear lights sold.

[paulsims2001]

Is it just the back box you have as mine jhas a janspeed and want to change the whole system dont suppose you have the middle section too?
Paul

[corkcorolla]

Doors, brakes and rear lights sold.

Thanks for these bits Lee.

A1 person to deal with lads and lassies,had him up very early on a Saturday morning to strip the car so I could make my ferry back home.
Thanks again mate. :+:

[Lee Haslam]

Is it just the back box you have as mine jhas a janspeed and want to change the whole system dont suppose you have the middle section too?
Paul

Just the backbox.

Lee

[Lee Haslam]

Doors, brakes and rear lights sold.

Thanks for these bits Lee.

A1 person to deal with lads and lassies,had him up very early on a Saturday morning to strip the car so I could make my ferry back home.
Thanks again mate. :+:

No worries mate, always good to help out another MR2 enthusiast. :+: